How to Install MYGIG Unit into 05-07 LX

Items needed to install MYGIG into Pre-08 LX

(1) MYGIG RER Nav Radio****low speed model only****Chrysler part# 5064401AH or higher revision. Example part# ending in AI or AJ or higher.

(2) Coastal MYGIG adapter lock pick with optional A/V harness***Do not get confused with MYGIG lock pick***
currently coastal only makes the adapter

(3) Nav Antenna for MYGIG

(4) Mopar Mic for U-Connect operation Part#82211743AB for about $35-40(uconnect is built into unit, Mic is required for operation)

(5) Clock Fix Firmware Update Disk (clock on mygig would normally not work in 05-07 LX, this corrects the problem)

the next 2 items are only require if you intend to subscribe to Sirius. Sirius is built into mygig, these items are required for proper operation

(6) Sirius Sat Antenna Extension Cable - Chrysler Part#05064159AD(2 may be required depending how you route it) (only required if your going to subscribe to Sirius)

(7) Terk Sir-SP Splitter (only required if your going to subscribe to Sirius)

(8) Cable Tie Wraps

Tools Requires: Basic Hand Tools


Installation Instruction:

IMPORTANT: Prior to beginning disconnect negative terminal from battery


(1) Old Head Unit Removal

(A) Remove Bezel
(B) Unplug Clock harness(if applicable), ESP switch harness and HVAC harness
(C) Remove Radio by removing (4) screws and unplugging all connectors from rear of head unit.

(2) Prepare Car and Lockpick Adapter


(A) Install New MYGIG NAV antenna(swap out with REC antenna or just adhere to top of plastic duct work behind radio)
(B) Route Sat Extension cable(s) from rear of car where old sat tuner is installed to front of car behind radio. Run the cable underneath the side trim that holds the carpet down then under the dash to back of the radio.
(C) Install U-Connect Mic to place of your choice, I mounted mine to the top left hand corner of the windshield. (See picture below)Run the wire under the a-pillar then under the dash to behind the radio.
(D)Configure dip switches of lockpick adapter unit per lockpick adapter instructions.


(2) Prepare MYGIG unit

(A) Plug in NAV antenna
(B) Plug in AM/FM antenna adapter supplied with lockpick adapter to MYGIG
(C) Plug in AM/FM antenna cable into adapter.
(D) Plug in SAT extension cable into MYGIG
(E) Plug in male end of lockpick adapter T-harness into rear of MYGIG
(F) Plug in Female end of lockpick adapter T-harness into factory radio harness
(G) Plug in U-connect Mic into MYGIG
(G) Plug in optional Lockpick adapter multimedia harness into rear of MYGIG (optional)*this will give you A/V input and output capabilities. For example, rear/front camera input, Audio/video out to headrests or Audio/video input from VES system.

(3) install Radio & Lockpick Adapter

(A) Install MYGIG unit car and secure with (4) screw removed from step 1C.
(B) Place Lockpick adapter underneath MYGIG unit (in back of HVAC controls

(4) Perform SAT info EVIC fix using TERK SIR-SP Splitter
*this is only required if you plan on subscribing to Sirius.

(A) Wire the Terk splitter into old sat tuner.

Unplug old uconnect just pop the glove box door out and you will see it mounted to the right, just unplug the connecter and you should be good to go.